SS100 & JJ100 tube layout

  • Thread starter Thread starter fab58
  • Start date Start date
F

fab58

New member
Is the tube layout for the SS100 & JJ100 the same as the BE100?

Looking at the amp from behind:
(Left to Right)

v1 HBE/Boost
v2 BE/Clean
v3 Cathode Follower
v4 Driver (tube closest to power tubes)

Thanks!
 
On the jj the first is just clean. Drive,cathode then phase. Clean on the other amps is also the first tube.
 
RACKSYSTEMS":2wka9hx0 said:
On the jj the first is just clean. Drive,cathode then phase. Clean on the other amps is also the first tube.

Thanks Dave!

Just to confirm, the SS has the same layout as the JJ?

Is this info still correct for the BE-100?:

"Farthest from the power tubes is the HBE/boost tube. The next is the BE and part of it is clean. Then the cathode follower and then driver tube. Recommended tubes are tungsols in the first 2 slots. Chinese preamp tubes in the next 2 slots and finally jj el34 or e34l tubes. You can buy tested to my spec tubes from Valve Queen. Hope that helps."
 
No the first tube is HBE or Boost and clean on both amps.
 
Well there is no boost/HBE on the Cantrell. On that the first tube is only clean.
 
Back
Top