moltenmetalburn
Active member
atrox":1ckv0p06 said:moltenmetalburn":1ckv0p06 said:Put the parametric filter in the FX section to approximate amps.
For example: diezel dmoll- use the LEAD setting, set high pass to 40, low pass to 6.3k and set the low mid to a Q or 4 and volume to -4 or -5 for midcut. Nails 95 percent of the vibe of my Dmoll when A/B.
Wih my axe fx as a data resource I just look at the models to see where the highs and lows are filtered and I start there which is a major part of indivdual amp voicings.
Unfortunately you cannot use the EQ and delay simultaneously. ( a huge oversight). With a few small changes the V2 of the katana could be PERFECT.
The clunky fx setup where you cant just use what you want, no tuner and limited MIDI are my only conplaints.
Going to try it as the wet side of a W/D With the Dmoll feeding its preamp into the katana loop return.
Using it as FX and poweramp.
Sure you can. Slap the ParaEQ in the Mod section and adjust the chain so the mods are in the loop. Then you have the delay free to use.
This is how i have my main gain channel set up
Very cool, thanks BUT i use the ts808 so id lose that. Failed to mention that earlier.
I WANT booster up front, delay AND eq in the loop all at once.