
BeZo
Well-known member
Depends on how the profile was created. Are you running a profile of a mic'ed cab through a cab? I'm in a band where the guitars are run through a Helix and split at the preamp to two sources. One goes to a Mesa 50/50 and a Recto cab, and one gets IRs to go direct to FOH. I am familiar with this setup.Ok, forget the 'variables' I mentioned. Play the Kemper through the same cab that one would use for their favorite tube amp. The powered Kemper is what I mean. Play the tube amp through the same cab.
Then, in the room, how does it sound/feel? If it's close enough, great. If not, then move on from it.
Since I simplified it for you, does this make sense?
If you are going to run that experiment, keep apples to apples and DI the speaker out for the profile. I, indeed, would like to that experiment. Just make sure to volume match both sources.