4 stage MOAB Marshall 2204 JMP w/clips

[RedPlated]

Sounds killer. You packed a lot in there, impressive! This is what the splatter Marshall needs! Already has the tube, an additional board, and its full sized chassis. Does the extra stage require any additional knobs or switches?

Thanks. It’s really versatile with the pull cut and 4th stage.

No extra knobs or switches. Just a high and low input is all that’s needed. On the 800’s I just open up the two additional input holes that are already in the chassis. The old input holes are used for the 6 way rotary diode select control and the diode clip level knob that blends diodes in and out of the circuit.

 

[John4021]

Thats so cool where you put the extra preamp tube.
Is that a (done before) location?

 

[RedPlated]

Thats so cool where you put the extra preamp tube.
Is that a (done before) location?

Wish I could say it was my idea but it’s been done before out the side like that. Albeit in a different area but similar idea. Theres just absolutely no other room in small 50w chassis. The turret board setup is all my design though. Most guys just use tag boards.