First time to use Captor X, and I have a YAMAHA UR-44 audio interface. When I read the manual of Captor X, it doesn't mention which input of the audio interface I should connect to. I do know the output of Captor X is XLR type, but my UR-44 has 4 inputs in the front panel. Inputs 1&2 are Mic/Hi-Z, and inputs 3&4 are Mic/Line.
There are 2 line-in inputs at the rear panel. I check the manual of UR-44, it says, the mic inputs can take -52dBu ~ -8dBu, line-in is -32dBu ~ +12dBu, and Hi-Z is -44dBu ~ 0dBu. The output of Captor X is XLR Balanced and its maximum level is 15dBu, which is adjustable by the output knob. My guess is, I can connect the output of Captor X to the 4 inputs in the front panel of my UR-44, and if the output is too high, I simply turn down the output a bit on the Captor X. Or I can say, inputs 3&4 is better, because their line-in can take up to +12dBu, am I right?
Thanks a lot!
There are 2 line-in inputs at the rear panel. I check the manual of UR-44, it says, the mic inputs can take -52dBu ~ -8dBu, line-in is -32dBu ~ +12dBu, and Hi-Z is -44dBu ~ 0dBu. The output of Captor X is XLR Balanced and its maximum level is 15dBu, which is adjustable by the output knob. My guess is, I can connect the output of Captor X to the 4 inputs in the front panel of my UR-44, and if the output is too high, I simply turn down the output a bit on the Captor X. Or I can say, inputs 3&4 is better, because their line-in can take up to +12dBu, am I right?
Thanks a lot!