[HELP] Connecting Behringer FCB1010 to Randall RM100

[msuwendy]

Hi Everyone

I've been struggling to connect the Behringer to Randall RM100 assuming the DIP switch is in channel 16

How to set the pedal to channel 16, is it by using the down button (hold 2 second), press UP once, choose pedal 1 (hold untill it blinks), press UP, Input the value (is this where we put the 16 cause been doing that untill im frustrated) after i press the up button it always goes back to choosing the pedal

I used 5 pin MIDI cable, Midi out from the footswitch and MIDI in on the amp

I just need help to change the channel cause i bought this head without and footswitch included

Thanks a lot

 

[Jun Tatsuoka]

http://host.mtnsys.com:81/faq-fcb/PCEditorBeta.htm

much easier to edit

I think the first page in edit mode is the relay switches?

 

[msuwendy]

hi thanks a lot for the help, honestly i got no cable to plug in the pedal, and ive check my randall rm100 in midi channel 16 and the midi pedal is in channel 16 as well, but to assign the first switch and second and third to change the channel what should i do?

 

[Jun Tatsuoka]

Is the FCB working with other MIDI equipment? maybe the MIDI cable has problems.
Since finding these FCB editors, I forgot how to manually program the foot controller esp with the UNO eprom installed.

I do remember the FCB is capable of simultaneously sending 5 Program Changes on 5 different MIDI channels. So you only have to program one of the five switches once in edit mode.