*RIG TALK RIDES!*

[Gsxrbusa]

This:
http://www.cardomain.com/ride/225656

1999 Mitsubishi Eclipse GSX

11.45 @ 125.08 MPH
22 PSI ON 93 OCTANE PUMP GAS - NO N2O
in street trim driven to the track and home, a/c and stereo kicking!!
Approximately 540 HP, 470 AWDHP

AWARDS:
My GSX won
"Best Mitsubishi" at the Louisiana Import Drags Show & Go Competition on 10/20/2002
"Best Mitsubishi" at the Import Face-off on 03/20/05
"Street Quik 8" winner at the Import Face-off on 03/20/05

Basically it's stock

ENGINE:
Magnus Motorsports Stage 4 1G 2.4 L 8.5:1 Long Rod short block (Ross/Pauter)
Magnus Motorsports Stage 3 1G cylinder head (Supertech components, Cometic HP, A1 H-11 studs)
Magnus Motorsports sheet metal intake
Magnus Motorsports 1G/2G install kit
Forced Performance FP4R cams
Fidanza adjustable cam gears
Concept Racing solid lash adjusters (16)
1G external oil cooler/oil filter housing
Setrab 119FP8 fan-pack oil cooler
-8 braided stainless steel lines from housing to cooler and back
Jaz mini breather catch can

FUEL:
Bosch -044 fuel pump (330 lph @ 75 psi)
VPE big bore fuel rail
Earls -8 1-way check valve @ inlet to the fuel rail
FIC 1240cc Ball/Disc injectors
Aeromotive A1000-6 1:1 AFPR
Aeromotive 12301 fuel filter
-8 braided steel line from the screen pick-up to the fuel rail
-6 braided steel line from the fuel rail to the AFPR
-4 braided steel line from the AFPR to the return line
1G throttle body/2G TPS
Fuel pump re-wire w/10 gauge wire

FUEL MANAGEMENT:
DSMLink v2/2.5 client software
MafTranslator v1.36
3.5 inch LS1 maf
AEM UEGO wide-band controller w/add-on a/f gauge

IGNITION:
AEM C2DI
Buschur Racing COP
93-94 Hall Effect CAS

TURBO:
HKS TO4Z turbo
VPE S/S tubular manifold
Tial 44mm wastegate
Tial 50mm BOV
GReddy Profec Type-s boost controller
Garrett/PTE 24x12x4 FMIC w/custom tanks & piping
Dejon Tools 4" intake pipe

TRANSMISSION:
TRE race prepped transmission
Speed Design 4-spider center diff
Torrington bearing mod @ center diff
3-4 hub sleeve upgrade
Cryo treatment on all hard parts

CLUTCH:
Clutch Masters 2500lb pressure plate
Clutch Masters ceramic 4-puck sprung hub disc
Clutch Masters billet aluminum flywheel w/steel face

COOLING:
Fluidyne radiator
Fal Twin-line fans
160 deg thermostat

EXHAUST:
VPE 3 inch downpipe
Custom 3.5 inch exhaust
Borla XR-1 3.5 muffler
Dynomax 3.5 Bullet resonators (x2)

SUSPENSION/HANDLING:
Eibach Pro-kit 1" springs which have been cut to lower the car a total of 2 inches
KYB AGX 4-way adjustable shocks
Ingalls adjustable camber kits at all four wheels
Front/Back strut tower bars
18x8 Rays Engineering/Volk Racing AV3 wheels
Nitto NT555 225/40ZR18 tires
Metal Master brake pads

EXTERIOR:
HID Xenon headlamps w/ballast & igniters
PIAA Ion fog lamp bulbs
Clear corner lamps w/amber bulbs
Vehicle has been de-badged

INTERIOR:
MOMO shift knob
Red interior lamp bulbs
Super Green neon needle kit installed at instrument cluster gauges
Windows tinted w/Graphite tinting 20% rear - 35% quarter glasses - 50% door glasses
Photos
Parking Garage 007.jpg Parking Garage 008.jpg Parking Garage 013.jpg Parking Garage 027.jpg Turbo 049.JPG Turbo 048.JPG Turbo.JPG Intercooler 027sm.JPG

Damn bro, you have sunk a lotta cash in that bad boy! I bet you have surpised a few guys on the street laying down those times. What kind of 60' times you pullin off?

 

[Jay Strange]

Whoa Bro! Wear a mask!!!

I don't paint enough anymore to worry about it. My booth leaves almost nothing in the air.
When I painted alot I wouldn't be spraying without one.[/quote]


Git'er done

 

[Death by Uberschall]

Damn bro, you have sunk a lotta cash in that bad boy! I bet you have surpised a few guys on the street laying down those times. What kind of 60' times you pullin off?

1.68 60ft on full street trim, no burn out because it's AWD.

It always blows peoples minds at the track. I go around the water hole, line it up and throw down mid 11 sec passes. Then drive it home with the a/c blowing, the stereo kicking and the cruise control set.

I have a couple of older vids, but no way to load them here.

 

[Gsxrbusa]

Damn bro, you have sunk a lotta cash in that bad boy! I bet you have surpised a few guys on the street laying down those times. What kind of 60' times you pullin off?

1.68 60ft on full street trim, no burn out because it's AWD.

It always blows peoples minds at the track. I go around the water hole, line it up and throw down mid 11 sec passes. Then drive it home with the a/c blowing, the stereo kicking and the cruise control set.

I have a couple of older vids, but no way to load them here.

That's sick bro. AWD ultimate in hookin up. I raced my Hayabusa for a number of years. 60' times were 1.8 -1.9 ish. Hard as hell to launch a 10sec bike on a street tire with no bar and not stretched. . The track altitude is 5000ft were I race so the index is .8, I was running 10.3 -10.5 depending on if I fucked up the launch or not ( wheelie, bog, light up the back tire... ect) I found some time slips here, i will post.

 

[Viper]

 

[Gsxrbusa]

Damn bro, you have sunk a lotta cash in that bad boy! I bet you have surpised a few guys on the street laying down those times. What kind of 60' times you pullin off?

1.68 60ft on full street trim, no burn out because it's AWD.

It always blows peoples minds at the track. I go around the water hole, line it up and throw down mid 11 sec passes. Then drive it home with the a/c blowing, the stereo kicking and the cruise control set.

I have a couple of older vids, but no way to load them here.

Here are my Hayabusa time slip and my Harley Davidson Softail custom. Remember the index is .8 so at sea level the busa would be layin down mid 9sec passes and HD would have been in the 11's.

 

[IntenseJim]

My favorite winter rides are leaning up against the wall

His and hers:

My ride in about 45 minutes:

 

[JTyson]

Here is a pic of my 68 Camaro I just finished.

This is my dream car, blue with 2 white stripes down the middle please
its perfect

 

[Death by Uberschall]

Damn bro, you have sunk a lotta cash in that bad boy! I bet you have surpised a few guys on the street laying down those times. What kind of 60' times you pullin off?

1.68 60ft on full street trim, no burn out because it's AWD.

It always blows peoples minds at the track. I go around the water hole, line it up and throw down mid 11 sec passes. Then drive it home with the a/c blowing, the stereo kicking and the cruise control set.

I have a couple of older vids, but no way to load them here.

Here are my Hayabusa time slip and my Harley Davidson Softail custom. Remember the index is .8 so at sea level the busa would be layin down mid 9sec passes and HD would have been in the 11's.

Very nice. I have a friend here that has a Turbo Busa and it's just sick. Doesn't matter how fast or what gear, he can controllably walk it up onto the rear wheel no clutching needed. Can't keep clutch packs in it though.

 

[Death by Uberschall]

My ride in about 45 minutes:

Nice ride.

 

[jet66]

I built the car to promote my Business Screamin' Performance.

I looked up the shop and see you are in Merritt Island. I'm down in Palm Bay. (And no, I don't have a meth lab, nor a grow house. ) That's a good looking car, along with a lot of others in this thread.

Mine's a 2006 Buick Rendezvous, with the 3.6L V6, a hand-me-down from my dad. It's nothing cool, but I don't owe any money on it, it seats 6 comfortably, and with the middle seats out, I can carry a 19 cu-ft refrigerator inside and close the rear hatch all of the way. Once my son graduates high school (next year) I will be looking at a fun car to work on at home. Maybe a 3rd or 4th gen F-body.

 

[RamoRenDez]

...

 

[diagrammatiks]

sigh. I'm 25 and I drive a family sedan.

there she is before I filled her with mcdonalds and frappes.

335xi. the 4.5 0-60 isn't that bad for highway driving I guess. Needs more gain. .

 

[Green Bastard]

Holy shit, you guys have some mean cars.

that fairlane looks rad

I live in the city (a small one) so 99% of the time i get around in some of these

and then for lugging gear around i go for something practical and very uninteresting

 

[JohnnyC]

i drive a stock mazda 6 MPS (i think you yanks know it as the mazdaspeed 6?)
AWD turbo with leather pack

looks exactly like this one

and i drive in the front passenger seat and also on the "wrong/left" side of the road.

 

[headlessdeadguy]

i drive a stock mazda 6 MPS (i think you yanks know it as the mazdaspeed 6?)
AWD turbo with leather pack

looks exactly like this one

and i drive in the front passenger seat and also on the "wrong/left" side of the road.

Damn those Mazdas look just like a Corvette.

 

[Death by Uberschall]

i drive a stock mazda 6 MPS (i think you yanks know it as the mazdaspeed 6?)
AWD turbo with leather pack

looks exactly like this one

and i drive in the front passenger seat and also on the "wrong/left" side of the road.

Damn those Mazdas look just like a Corvette.

 

[JohnnyC]

wat?
RE:
mazada looking like a vette?
someone care to fill me in?

 

[Death by Uberschall]

wat?
RE:
mazada looking like a vette?
someone care to fill me in?

Look at the pics you posted!!

The have a hot link banner in their place.

 

[155]

team green here....love the muscle cars boyz