Search results

I have a sweet Bogner Duende 2x10 greenback combo. Was having an issue with it blowing fuses after a few years of working fine. I use it at very very low volumes in my living room. Sounds absolutely killer and I love this thing for this use, every guitar sounds awesome thru it at any volume...

Was having an issue with it blowing fuses after a few years of working fine. I use it at very very low volumes in my living room. Sounds killer. After consulting with Bogner I replaced the rectifier tube, then both power amp tubes and it worked fine for a while. Then out of the blue it blew a...

Poor management has it's price. Too bad but understand completely. Vote with your $$$$ for businesses

Anyone watch? thoughts? I think the sound guy pulled a very quick mix, Eddie was buried in the beginning. Band A+, DLR C- IMO

Anyone know what the tube order is on these? Only 4 tubes, I am assuming one closest to power tubes is PI, then next is 5751 for loop, then 12ax7 pre and input stage 12ax7 (closest to input). I've looked everywhere for this info, can anyone help? Thanks

Has anyone checked their bias setting on the test points on the back of their Stealth amps? Just wondering what its reading, mine shows 28 mA, how is it reading bias from all 4 tubes? and what should it set at? There is ZERO info in the manual for this, they just say take it to a tech which is...

Have a first run BE100. Is it possible to mod to the new version? I wish I had waited a the new version has all the features I would want but didn't know it would be available when I bought the original. Really costly to trade it in for a new one (I could buy another quality head with what that...

I have 2 mesa 1x12 cabs and I want to sit my Mark V combo on top of and use all 3 speakers, the combo's 12 and both the 1x12 cabs. Internal speaker is 8 ohms as are both of the 1x12's. Can I do this from an impedance standpoint and what is best way? I think the mesa has 2-8 ohm taps and 2-4 ohm...

Have several high end heads but just picked up this OD3 combo and wow! Fantastic sounding, best low volume amp I've ever heard too but gets plenty loud, cleans just are so deep and glisten, mid gains bark beautifully, and whoah, didn't expect the high gain to be so nice, big, chunky, singing...

Rear panel says "Marshall Master model 50W Mk2 Lead". I get a little confused with all the models of the older Marshalls. This amp has one channel, 2 inputs and gain and master volume controls along with bass, mid, treble and presence. Is this a JMP type amp or somehting different? desirable or...

I'm looking for a wildcard pedal for my new board, somehting I can change as needed for new "special effect" scenario i.e octave, flanger, etc etc. Anyone with experieice with either of these or compare and contrast. I only want to use one effect at a time so I don't really mind the reloading of...

Anyone ever try or use one of these? Gettin older and a 47lb 4x12 is really appealing (try as I might I tried 2 single 12 cabs and my 2x12 but I dont hear myself as well). Wondering what the speakers sound similar to in the celestion range? Thanks for the help

Just curious, on a stereo power amp if I oly want to use one channel how can I do this? I was always under the impression that i HAD to have a speaker on each output even if one of them was turned down....is there a safe for sure way to do this? Thanks

Is there a easy mod that i could do to give additional top end and brightness only to channel one mode 1 clean on the Einstein? I love the sound of all the other modes, texas and mega and switch between them a lot but always have to raise the treble for the cleans I want and then decrease it for...

I know the Cameron Atomica is closer to the BE100 but if anyone owns both of these (CCV & BE-100)and can give me an idea of differences I would appreciate it. Thanks

Anyone with both and could give me the low down would be appreciated. Thanks

Anyone able to compare these two killer amps? Thanks

Is it me or do the guest guitarists on this show seem somewhat ham fisted and awkward? I watched Lynch this weekend and Jesus he looked like he was straining to play some pretty basic stuff and most of it was crap. I've noticed this with lots of guest guitarists on the show but Lynch was really...

I have posted this in the Bogner section with no response so thought I'd post it here too so i could ask for some opinions from all of our resident amp guru's/builders. I am trying to bias up a set of GLKT77s in my XTC 20th and I am getting variation in plate voltage from 498 to as high as...

Trying to bias up a set of GLKT77s in my XTC and I am getting variation in plate voltage from 499 to 529, does this seems normal? Bias was also moving from 30-33 to as high as 37 then could go back eventually. This is after an hour or more of being on and running thru my Furman voltage...