Amp Switchers .......

[Clp45]

Cheers I’ll give it a go as I have one inbound not a deal breaker if it doesn’t work.

 

[skoora]

The Attenuator loop is going to be a speaker output signal so make sue you use a device or load than can take it to a line level signal for processing. That's what the Bray LO-1 is doing.

 

[skoora]

I ended up ordering the da Lisle 4x4 Pro Plus ....
like Hatter mentioned .... I'm getting one pretty much for the same reasons .... MIDI isn't really needed in my world . ( not yet anyway )
it's 99% to just let me play my different heads without having to reroute my whole setup each time .... and 4 and 4 should be plenty for me ... if anything maybe one will head will be swapped out once in a great while ... but I'd like to get down to just 4 .
Oh ... and the Pro Plus will let me run two cabs .....
thanks for the input guys !

Nice, I think you'll dig it. I will say wiring up all the George L I needed for 10 amps was something..lol Definitely learnt to test each cable as I went. I'm moving the Delisle I have because I want to go the midi route with the KHE. Have a GCX audio switcher I dusted off for pedals and channel switching and thought it could be cool to use the ground control to do all of it.

 

[griff10672]

Nice, I think you'll dig it. I will say wiring up all the George L I needed for 10 amps was something..lol Definitely learnt to test each cable as I went. I'm moving the Delisle I have because I want to go the midi route with the KHE. Have a GCX audio switcher I dusted off for pedals and channel switching and thought it could be cool to use the ground control to do all of it.

yeah .... I'm on Redco right now getting Mogami cable .... for the ins and outs ... and the speaker runs .. going to need at least 36 jacks ..... lol

 

[Elric]

I just used the loop in my Powerstation. Just figured why cable up every loop when I just need one. Also that way I didn’t have certain effects dedicated to one amp when I might decide I want it on another.

I got the DeLisle with the loop switching (8x6 Pro Plus w/ Attenuator) even though I have a PS2.

This allows me to run my Syn2 preamps, Kraken V4 preamp, AxeFx III, or Quad Cortex amp models into any given power section that is hooked into the switcher.

So, I can run my Synergy preamps into any different head (EL34, KT77, 6L6, EL84, whatever) power amp at will in addition to the actual amp's preamp by changing scenes on the AxeFx. It's pretty mind blowing.