L
LukeCurd
New member
This I did for my buddy Bryan. We are still swapping pedals in and out of the loop rack so I don't have pics of that yet.
The G-System controller is held to the board using 4mm washers and M4 screws. The rest is hook and loop. I used a 9v 1 spot you can see on the top are left. That is for his power on the Wah and Rotovibe. The signal then goes into the G-System Brain. Since the wiring is so tight I opted to use a 1/4 right angle adapter on the roto send since it makes it easier to plug in and out. I made a TechFlex cable that carries his 1/4 mono signal along with 25ft of Cat5e for the controller to brain. The Boss Expression pedal is for his univibe patch and delay.
The G-System controller is held to the board using 4mm washers and M4 screws. The rest is hook and loop. I used a 9v 1 spot you can see on the top are left. That is for his power on the Wah and Rotovibe. The signal then goes into the G-System Brain. Since the wiring is so tight I opted to use a 1/4 right angle adapter on the roto send since it makes it easier to plug in and out. I made a TechFlex cable that carries his 1/4 mono signal along with 25ft of Cat5e for the controller to brain. The Boss Expression pedal is for his univibe patch and delay.
