Rig-Talk
https://www.rig-talk.com/forum/

What is the proper way to plug/unplug cab?
https://www.rig-talk.com/forum/viewtopic.php?f=75&t=211492
Page 1 of 1

Author:  Sergii [ Thu, Jun 25, 2020 3:10am ]
Post subject:  What is the proper way to plug/unplug cab?

For instance im using a cab, with attenuation set to MID. Then I need to switch to "Silent mode" - headphones only. Should I turn everything off (power off) before unplugging cab? Or is it ok to only put amp to Standby?

Another question there is not "power button" on Captor X - so if I would like to turn it off and use just attenuation for a while, should I pull off power supply cord? Or how?

Author:  Jason Wilding [ Thu, Jun 25, 2020 5:32am ]
Post subject:  Re: What is the proper way to plug/unplug cab?

When you say you are using a cab with attenuation set to MID, what are you specifically talking about?

Author:  Sergii [ Thu, Jun 25, 2020 5:45am ]
Post subject:  Re: What is the proper way to plug/unplug cab?

Using this toggle set in between FULL and LOW.

Attachments:
Screenshot 2020-06-25 at 12.43.14.png
Screenshot 2020-06-25 at 12.43.14.png [ 1.03 MiB | Viewed 195 times ]

Author:  Basstyra [ Fri, Jun 26, 2020 7:59am ]
Post subject:  Re: What is the proper way to plug/unplug cab?

As long as the amp is on standby, you can plug and unplug the speaker and Captor X without problem.

To power off the Captor X, simply unplug the power supply, like you would on any pedal :)

Author:  Sergii [ Fri, Jun 26, 2020 8:12am ]
Post subject:  Re: What is the proper way to plug/unplug cab?

Basstyra wrote:
As long as the amp is on standby, you can plug and unplug the speaker and Captor X without problem.

To power off the Captor X, simply unplug the power supply, like you would on any pedal :)


Awesome! Thank you.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/