Is there any power amp better than a Fryette PS-2/PS100 for a modeller?

[romanianreaper]

Maybe I am reading something incorrectly, but does the PS-100 only have one speaker out? I run two 4X12's with a PS-2. Thought about moving to the PS-100 but want to run two cabs.

Looks like you can but have to daisy chain them. There is only one output jack. From the manual:

SPEAKER OUT – Connect this output jack to any speaker cabinet or combination of cabinets that
total 2/4, 8 or 16 ohms impedance. For example, when using a 16 ohm cabinet (typically a 4x12
cabinet), you will set the switch to 16 ohms. To connect multiple cabinets, simply use an unshielded mono Y adapter or splitter cable.

 

[nightlight]

Looks like you can but have to daisy chain them. There is only one output jack. From the manual:

SPEAKER OUT – Connect this output jack to any speaker cabinet or combination of cabinets that
total 2/4, 8 or 16 ohms impedance. For example, when using a 16 ohm cabinet (typically a 4x12
cabinet), you will set the switch to 16 ohms. To connect multiple cabinets, simply use an unshielded mono Y adapter or splitter cable.

Oh wow, that's a dealbreaker for me then. I like having two outputs.

 

[Racerxrated]

IF you can find one, any vintage HH power amp will reproduce the tone of your pre/modeler without coloring the sound much if at all. This is why many pros back in the 80s/90s used them to slave out of their main amp to multiple cabs live. I have an M900, which is essentially the same amp as the V800 but with 2 less output jacks. The first time I used it to slave out my Wizard MC100, I was amazed at how identical the tone was out of my slaved cabs vs the main cab that the amp used. No difference in tone at all.
They are getting harder to find though. Unfortunately.

 

[bste328]

Oh wow, that's a dealbreaker for me then. I like having two outputs.

Just grab a Palmer Cab M. 27 bucks I use it with my PS100 and can use cabs in stereo or parallel when I need to