Mezzabarba

[guitarxtc]

Le

Let’s just say component choices inside them don’t make a lot of sense to me, and to compensate for the component choices, that coupling capacitor sizes are changed from typical SLO values to keep things tight and aggressive.

A SLO with a boost will have a bigger bottom end and not as much Johnson noise at the cost of less gig friendly features.

I traced Trinity board because i wanted to mod it, identical resistors and caps values like SLO,they added extra preamp tube for clean and NFB pot.

 

[dead-pan]

I put my Trinity up for sale for a few days recently, but pulled it. It’s a killer amp IMO. Channel 2 is completely usable to me for a low/mid gain dirt tone. It don’t think it works well for a high gain rhythm channel. I bet that’s what he means.

I do a lot of low gain stuff and it’s great. Turning on bright switch tightens the low end a little on that channel.

Ch 2 and 1 are fantastic for this. Kinda Voxy.

 

[dead-pan]

I traced Trinity board because i wanted to mod it, identical resistors and caps values like SLO,they added extra preamp tube for clean and NFB pot.

I have a Trinity and SLO100. They don't really sound alike.

 

[cragginshred]

Curious why channel two was unusable for you?

I have an mzero and an ES which I love and have done over 100 shows with, but need a dedicated clean channel, I’ve been eyeing the trinity.

It just did not capture the marshall vibe in mids or gain department. But then again back then I used way too much gain.