Axe FX help...need some help

[Darden]

If your cab is mono, and you have to run mono from the Carvin. You can do that by:

A) Only running out of one of the channels (1/4 inch speaker out) of the Carvin at 75 watts

B) Running the Carvin in Bridged mode (150 watts), which means you MUST be hooking up to the Red Binding posts on the back. That means you must have a speaker cable with a 1/4 in plug one end for your cab, and that splits into one postive, and one negative lead on the other end. Those leads are what hook up to the Red binding posts. No other way of connecting for Bridged mode will work.

From the manual:

The DCM150 can be operated in bridge mode if you require a 70V dis-tribution speaker system or a high powered mono (single channel) amp.With your amp off, push in the rear BRIDGE switch after you have madeyour speaker connections to the rear center RED binding posts (ch 1 is+ and ch 2 is -). No other speaker jack or binding post can to be used at the same time!”. The INPUT and LEVEL is handled by channel 1. Channel2 is non-operational.

Here's a link to the full manual:

http://www.carvinguitars.com/manuals/DCM150.pdf

 

[putnut77]

B) Running the Carvin in Bridged mode (150 watts), which means you MUST be hooking up to the Red Binding posts on the back. That means you must have a speaker cable with a 1/4 in plug one end for your cab, and that splits into one postive, and one negative lead on the other end. Those leads are what hook up to the Red binding posts. No other way of connecting for Bridged mode will work.

Thats what I needed to know! Thanks!

 

[006]

Hmm yeah I probably should have read the manual from Carvin's site and I would have seen that myself